Pro FPV Gimbal (Timing Belt)
Pro FPV Gimbal (Timing Belt)
Pro FPV Gimbal (Timing Belt)
Pro FPV Gimbal (Timing Belt)
Pro FPV Gimbal (Timing Belt)
Pro FPV Gimbal (Timing Belt)
Pro FPV Gimbal (Timing Belt)
Pro FPV Gimbal (Timing Belt)
Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)
  • Load image into Gallery viewer, Pro FPV Gimbal (Timing Belt)

Pro FPV Gimbal (Timing Belt)

Regular price
$99.98 USD
Sale price
$99.98 USD
Regular price
Sold out
Unit price
per 

Medlin Drone single-axis "Timing Belt" FPV gimbal.  This kit comes preassembled and configured!

Advantages compared to the Basic (Pushrod) FPV Gimbal include stiffness, perfectly consistent ratio, large range of motion, and aesthetic/professional appearance.

If there is not a kit for your frame available, you can commission a new FPV gimbal design for almost any frame.  This gimbal can be controlled via head tracking as well as various other methods.

Works with Analog, DJI, HD Zero, etc. FPV systems, may require an FPV camera extension cable depending on your setup.

Please Note: FPV camera extension cable is not included, cables for DJI and Analog are sold separately.  To power the servo you will need 5V and ground, we sell a 5V Regulator/BEC

Kit Includes:

-3D Printed Gimbal Design (Includes Pulleys and Strut) 

-1x Digital Metal Gear High Quality Servo - LDX-227

-1x Fiberglass Reinforced Timing Belt

-2x Main Bearings - Sealed Steel Ball Bearings

-2x Strut Bearings - Sealed Steel Ball Bearings

-1x M3 Axle 

-1x Stainless Steel M3 Hardware

-1x Capacitor 100uF 10V

-1x Servo Extension Cable

-1x Wire Shielding 

-2x Shrink Tubing 

 

Please allow lead time for printing, printing is done on an as-needed basis to avoid waste and is first-come first-serve. 

 

Required:

-Soldering tools

-Flight controller running Betalight, iNav, or another Cleanflight variant, with available LED pin or unused motor output pin and available 5v and ground pins.  However, if using TBS Crossfire or another receiver with ability to output an individual PWM signal on a spare output pad it can be used instead of the flight controller to control gimbal.